Quote Originally Posted by Hotolds442 View Post
Does the head of the cartridge show any marks on it like signs of sliding friction?
Do the bullets of the unfired, ejected rounds show rifling marks in the ogive?
Is the reloaded brass stuff that was fired in another rifle?
Are you neck sizing your brass or full length resizing?
What weight are the bullets of your factory rounds?
I have not seen any marks that would indicate where it is getting hung up at. Everything looks correct when I eject the casing. All rounds are firing if I can get the breach locked. Some of the brass was shot from another weapon, but I have been reloading my own cases that I have fired before. I just purchased a collet die and I do a full length size and then a collet neck sizing. I have just gotten this die and have loaded about 100 rounds since using it. Hopefully I can get to the range in a day or two. Factory loads have all been 55 grain. I just purchased some 50 grain and I am using some for the new reloads.