Well the .023 spring seems like the sure cure for me. I cleaned the excess grease off and slid a #13 Viton o ring over the stock screws because they bottomed out from my taking it apart so often. I measured the slop that allows the trigger to wiggle which was .032. When I get back on the laser machines, I'll program a stainless steel washer to remedy that. After all this, I think I have sourced a accutrigger and I intend on buying a Boyd's stock for it this coming week. I'm not sure I'm going to install the accutrigger in this one or wait until the 22-250 Axis follows me home.