FYI, my bolt was dragging pretty bad near the end of the "opening stroke" last inch, inch and a half. When at the store I basically blamed it on the empty magazine, shame on me. At home I removed the magazine and still had a problem. Clearance is very tight at the back end of the receiver. When holding the bolt at the end of the knob it puts just enough side pressure on it to make it drag to the point where it's a problem. I slopped it up with some Ultra Brite and worked it for a good ten minutes. It's better now but the logo is gone and the black oxide is gone where it contacts the receiver. No big deal but it should not have been like that. I'm going to take it apart and polish the whole bolt body on my buffing wheel. I wasn't crazy about the finish on it anyway. Maybe I will get it jeweled or fluted eventually.

Pennsylvania game laws state "Full Magazine permitted for deer hunting" doesn't say it has to be a factory magazine