Accu trigger

[jalmeter29]

Because the AccuTrigger has a thicker profile then the stock axis trigger it needs to be ground down a little to fit.

stock-->


AccuTrigger -->


You can see all that needs to be done is remove some material form the AccuTrigger so that the spring can sit low enough to fit.

I grounded down just the green part here-->


Only other thing I did is set the safety so the trigger will not pull when the safety is engaged. In my case the AccuTrigger safety set screw was to long so i had to back it out a few thousands. In my case i just garbed a file and shaved it down a little so I wouldn't have to brake the yellow glue stuff off.

Safety set screw-->


Do at your own risk. Do not attempt if you don't know exactly whats going on.

Let me know if you have any questions. And sorry it took so long to get these up.