Added a pillar mount job and it's laying in the stock like it should now. The front pillar if you could call it that was too low. Drilled it out and installed new one. It sits in there right now! It sure was nice to find that before i went much farther. I'm done messing with it other than trying different loads now. As soon as this ice and snow melts off I'm gonna run a few rounds through it.
I worked on the trigger.
pillar bedded the action
reinforced the stock
added about $25.00
Last edited by gunrack; 12-09-2013 at 07:23 PM.
Reason: Had more to say
Bookmarks