The following is what I have...i would assume the sizing die has the expander....correct? http://www.midwayusa.com/product/814...-br-bench-rest
Can you please be so kind an expand on " print the results".
Thanks,
Cat
The following is what I have...i would assume the sizing die has the expander....correct? http://www.midwayusa.com/product/814...-br-bench-rest
Can you please be so kind an expand on " print the results".
Thanks,
Cat
Expander, Yes.
Another reason I went with a bushing die is, it doesn't use an expander, just sizes down to the desired neck diameter, eliminating the chance of effecting the concentricity when the case is pulled over the expander. Don't sweat it though, a little trick I do when using an expander is to not lock it tight so when the sized case comes down on it, it pulls it center. Also, if you want to lock it tight, leave it loose, run the case up in the die, then when you bring the case down to the expander, stop when the case is pulling on it a little, centering it, then finger tighten the nut. Learned that from Darrel Holland.
"printing" The bullet holes in the paper target.
Bookmarks