Originally Posted by
DT400
This is what I do.
Remove die and drill and tap bottom of case to a 1/4-20 thread.
Reinsert die in press
Use a good quality 1/4-20 counter sunk screw about 1" 1-1/2" long
Insert head of screw into the shellholder, raise the ram and thread the screw into the base of the case and pull out with the ram. If you have different shellholder find one that grabs the screw head the best.
After I did this I realized my home made design is basically what a stuck case extractor kit is if you purchase from a store but since I had it all on hand already it was free..
Darrell
Bookmarks