Quote Originally Posted by Nandy View Post
Dont assume that, make sure. Call leupold unless you can find the specs in paper somewhere. I have seen rings specs for 15 inch/lbs and I have seen them up to 25 inch/lbs...
Not to hijack the thread but may I pontificate upon torqueing allen screws?
They are so small that they don't take much torque. I am amazed at how many stripped allen head screws I run across. It is more important to get an even torque on all four screws. Then let the Loctite hold them permanently.
Screws that have been removed and retightened can have a wide range of torque required to reset them. All four screws may require a different torque setting. Always hold the Allen wrench the same way in your hand. End of pontification.