Results 1 to 25 of 32

Thread: 7mm Dies w/37 deg Shoulder on 300WM Parent Case

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 07-03-2013, 08:21 PM #12
    BobT
    Status
    Offline
    Basic Member BobT's Avatar
    Join Date
    Dec 2006
    Location
    Missouri Ozarks
    Age
    65
    Posts
    710
    The 7MM Mashburn Super is also very close to what you are looking at, tapers to .494 at the body/shoulder junction but only has a 30 degree shoulder. This is another neck down in the FL sizer and shoot wildcat boasting speeds of over 3000 fps with the 175 grain Partition from a 24" barrel. Dave Kiff already has the print for this one it's #15106. I have been fooling around with it for a little over a year and it's good stuff.

    Bob
    Last edited by BobT; 07-03-2013 at 08:26 PM.
    It's better to shoot for the moon and hit the fencepost than to shoot for the fencepost and hit the ground!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Expanding Case necks and collapsing shoulder
    By Burr in forum Ammunition & Reloading
    Replies: 7
    Last Post: 06-24-2015, 07:51 PM
  2. MOVED: RELOADING/CASE FORMING DIES
    By 82boy in forum Ammunition & Reloading
    Replies: 0
    Last Post: 06-26-2011, 02:09 PM
  3. .243 parent case
    By calib in forum Ammunition & Reloading
    Replies: 35
    Last Post: 05-11-2010, 08:36 PM
  4. How would I form a 223 shoulder and neck, on a short 223 case?
    By briannmilewis in forum Ammunition & Reloading
    Replies: 23
    Last Post: 09-30-2009, 05:27 PM

Members who have read this thread in the last 1 days: 0

There are no members to list at the moment.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules