Do not bed the nut as you could change the barrel and it willnever line up in the groove's used for tightening the barrel.I would bed the entire reciever except what is behind the rear action ecrew as the tang should be freefloated alittle.You will have to roughen the surface meaning removing the finish that boyds over sprays in the bedding area so the epoxy will stick good.Use a good release agent on all parts and I use plumbers putty to fill voids when removing the trigger to do it right etc.I fill the area for the magazine to make sure you dont fill it in which would require removal to refit the magazine afterwords.There is a tutorial on the home page and there is one over on accurate shooter.com as well and many on you tube which I suggest you watch.
Bookmarks