Make a new one.
I'm trying to lighten the pull of my 3 screw trigger on a 110.I already put in the .040 wire but it still has a lot tension on the sear from the sear/bolt release spring.I can take the trigger spring completely off and still have a 3 1/2lb pull.What can be done to lighten sear spring if anything?
"An armed society is a polite society"
"...shall not be infringed" What's the confusion?
Make a new one.
You can polish the sear surfaces if you are skilled at metalworking. You don't want to remove much material.
You may also be dealing with a very heavy firing pin spring setting.
always test you rifle for proper function after adjusting a trigger. By that I mean closing the bolt fast/hard and bumping the stock hard with the safety off to see if the trigger holds.
You might be right about the firing pin spring.I'm going to try swapping bolts with another rifle just to see if that has any effect.
"An armed society is a polite society"
"...shall not be infringed" What's the confusion?
Different bolt,same results. My barrel for this action is finally on the way so it's time to order another SAV2.That'll fix it!
"An armed society is a polite society"
"...shall not be infringed" What's the confusion?
"Muzzle velocity is a depreciating asset, not unlike a new car, but BC, like diamonds, is forever."-German A. Salazar
Bookmarks