WOW Thomae...nice work! Thanks so much. You take excellent pictures and explain very well. I read your pictorial instruction about how to take the bolt apart, and was very impressed at the clarity of instruction.

Couple of questions about the stock mod:

1) Did you sand the plastic surfaces before adding the JB Weld (I assume it was the fast-setting type)? I do have a concern that JB (or clear epoxy) will not adhere very well to that slick plastic stock material.

2) Is the entire wrist area completely filled up with JB after the threaded rod is set in place, or is that the total amount of epoxy that you finally used?

3) How much better is the stock now that all this work has been done? Are you satisfied with the rigidity?

Thanks,
-Dennis