I don't like the accutrigger, but i definitely wouldn't remove the accurelease! Are you sure it is your finger that is causing this, or is it possible that the sear is not engaging at all when you cycle the bolt? That was always my issue. The common, and correct remedy is to increase the trigger pull weight. Of course if you like a light, sub 2 pound trigger then the accutrigger isn't for you.
Should you keep the accutrigger clean it up real good with lighter fluid while you're in there adjusting the pull weight, paying particular attention to the trigger hinge pin and the sear slot. The rifle comes with too much grease in both those areas, IMO, and it gets gummy. I also think the sear engaged more positively if it is dry (no grease).
Bookmarks