I have Millitt med with that same set up, the high rings are 1/8" higher,
Tanks Dean
Anyone here use a T36 on their Savage? I am looking for suggestions on Ring height and whether new mounts will be needed.
Thanks
I have Millitt med with that same set up, the high rings are 1/8" higher,
Tanks Dean
RUMs are like woman in Stiletto heals, you know they are going to put you in the poor house, but that has never stopped anyone from pursuing them.
So you are using the factory bases and Millett medium rings and a T36 on your BV? Whats the clearance like?
Thanks
If you're using a T36....get signature zee high. If weight is an issue, get Kelby standards
Sent from my DROID X2 using Tapatalk 2
Weight is not an issue. I have been thinking about using the burris just wasnt sure which height. Will I be able to use the factory bases on the BV with the High Burris rings or will I still need higher bases? This Rifle is for my Cousin as I already have a 40x setup with a T36 and Burris Signature Zee Rings
The Burris high rings are almost .600 you should be fine with those.
Tanks Dean
RUMs are like woman in Stiletto heals, you know they are going to put you in the poor house, but that has never stopped anyone from pursuing them.
How high is it from the top of the barrell to the top of the factory bases?
Thanks
On my rig the barrel is flush with they action, and then steps down 8" further down the barrel, but the scope bell is over the flush part.
Tanks Dean
RUMs are like woman in Stiletto heals, you know they are going to put you in the poor house, but that has never stopped anyone from pursuing them.
Bookmarks