open your bolt and pull the trigger while holding it close the bolt make sure it is unloaded
NO AMMO IN CHAMBER.
Yep, really can't figure this one out. Please let me know before I break something. I'm trying to check my protrusion without taking it all apart. Help!
open your bolt and pull the trigger while holding it close the bolt make sure it is unloaded
NO AMMO IN CHAMBER.
That sounds better than the method I just used:
Remove bolt. Move rear baffle around to where it would be with bolt closed. push on cocking pin. Allow cock pin to fall trapping your trigger finger between itself and bolt body cutout. Make sure your finger is in the way so you pad the fall of the striker. Run around trying to pull bolt off of finger. Use different tools including screwdrivers and forks to pry bolt off finger. Realize this won't work and go to plumbing kit to get channel locks and use these to relieve firing pin tension. Slowly remove finger and yell as feeling returns to the bloody stump that once was your trigger finger. Clean skin and blood from bolt body. Measure protrusion.
idiot
I use the edge of a table. They dont bleed and scream.
wonderful to see that other people do some of the highly intelligent things I do heal up fast
haha... Is there some sub-chapter of the Brotherhood of the Barrel Nut for people such as us??Originally Posted by pphreed1
.....................
................ "Oh Mama's, don't let your babies grow up to be Brotherhood of the Barrel Nuter's ..........."
I'd vote for the edge of a counter or table when the owner of said table ain't lookin' ............
Three 44s
;D :D ;D :DOriginally Posted by lwink
Oh, man that is TOO close to home.
I'm not alone in the world! :D
Isn't education by experience just xxxxing wonderful?
uj
It's easier to loosen the bolt assembly screw. You may as well take it apart, after you measure the protrusion, yer gonna want to re-adjust anyway.
"As long as there's lead in the air....there's still hope.."
I'm guilty of popping the cocking pin over w my finger as well. But it's not near as dramatic w my reduced power main spring and polished off detent.
Remember to get all of the blood off of blued surfaces, it will cause rust.That sounds better than the method I just used:
Remove bolt. Move rear baffle around to where it would be with bolt closed. push on cocking pin. Allow cock pin to fall trapping your trigger finger between itself and bolt body cutout. Make sure your finger is in the way so you pad the fall of the striker. Run around trying to pull bolt off of finger. Use different tools including screwdrivers and forks to pry bolt off finger. Realize this won't work and go to plumbing kit to get channel locks and use these to relieve firing pin tension. Slowly remove finger and yell as feeling returns to the bloody stump that once was your trigger finger. Clean skin and blood from bolt body. Measure protrusion.
idiot
Don't ask me how I know this.
Never kick a fresh turd on a hot day- Harry Truman
Bookmarks