So, I get my order form MuDwAy for 3 ejector springs. I take the Axis / Edge bolt out & proceed to remove the ejector retaining pin, ejector pin & spring.

I come to find out the inside of the bolt head must have been bored with a chainsaw & finished ground with a rock.
The inside of the bore is so rough I can't get the new spring to do its spring thing (ie - push the ejector pin out when tossing a spent case)...

The only things I have on hand are drill bits to clean it out with. If I use a .104" bit - twisted by hand to clean it out, I can still feel it's very "grabby" & I'm wondering.... If I rebore it out to .106" will it still function OK? The .106" bit is the next size up that I have on hand.

Anyone have any input, suggestions, advice, threats, innuendo..... anything? I'm all ears.... or eyes as the case may be.

Frank in Fla..... Hangin' on tight & ready to start the pumps.