Typically I smack it on the end with my action wrench with a rag on the mag to soften the blow a bit.
Others use a rubber mallet.
I am getting ready to bed my stock and I need to remove the mag well assembly from the receiver of my 111FCXP3 (detachable magazine, button release on side of stock). How does one go about doing this?
Thanks
"No free man shall ever be debarred the use of arms."
Typically I smack it on the end with my action wrench with a rag on the mag to soften the blow a bit.
Others use a rubber mallet.
some place a thin screwdriver under the l bracket and rotate the tool back and forth till it lifts up. its all downhill fromm there.
Bookmarks