It was a way of capturing or keeping the pin located as opposed to using a c-clip on one end and a head on the other.
I have recently become the proud owner of a factory 4 screw savage trigger. My intention is to use it on a Stevens 200 action. What does the 4th screw adjust? Tension on the trigger pin? Why? Should it be adjusted or ignored?
It was a way of capturing or keeping the pin located as opposed to using a c-clip on one end and a head on the other.
Thanks for your reply. I will just ignore it then as my pin has an e-clip.
you can push it to one side and set it. it may take out a little play.
.223 Rem AI, .22-250 AI, .220 Swift AI .243 Win AI, .6mm Rem AI, .257 Rob AI, .25-06 AI, 6.5x300wsm .30-06 AI, .270 STW, 7mm STW, 28 nosler, .416 Taylor
See...and I was using small motor thrust washers to take play out.
Bookmarks