JWW123 thanks for the suggestions on how to cut the angles.

The forearm shouldn't be a problem. Since I'm using a small table saw I will be able to do a push turn the stock and then pull through for the other side. Unfortunately, it's going to be a little more difficult with the butt though. I can't just pull through, due to the wide grip. I think you gave me the answer though. I'm going to try positioning the stock for the pull just past the grip with the blade down. I'll then recruit my Wife or Son to slowly raise the blade while I hold the stock in place against the rip fence. I should then be able to complete the pull through without cutting the grip area.

Here's another photo with a little more of the sanding done. I didn't get a chance to smooth out the front of the grip, but I did pick up some emery cloth so I'll get to it this weekend.