Hi,
I have an older 110 in 270 winchester with a factory laminate stock. It is not shooting like it should, so I took out a dollar bill and felt around the barrel and the tang, had a few snags, so I took the action out of the stock and fired up my dremal. After cleaning up a few small areas, I looked at where the recoil lig sits and it was fine, however, I notice a crack in the laminate where the front action screw is, it is parallel with the stock, and goes about 1/2 the way down of its own thickness.
What type of glue would be best to drip into this crack ?
Also, can I expect this to last ?
It is a nice looking stock, and I would like to keep it .
Thanks