So went to shoot my 110 in .30-06 the other day. Previous times on the bench went well. This time I had 6 rnds with me for testing...4 of the six didnt shoot. The past few days I have tried to shoot with similar results.

Pics of an unfired bullet
[img width=573 height=768]http://i1204.photobucket.com/albums/bb406/jgloveracob/photo-4.jpg[/img]

[img width=573 height=768]http://i1204.photobucket.com/albums/bb406/jgloveracob/photo-1.jpg[/img]

[img width=573 height=768]http://i1204.photobucket.com/albums/bb406/jgloveracob/photo.jpg[/img]


My first thoughts was the primer pockets were drilled too deep, this may still be true but then I looked at firing pin protrusion and found this..

[img width=573 height=768]http://i1204.photobucket.com/albums/bb406/jgloveracob/photo-3.jpg[/img]

[img width=573 height=768]http://i1204.photobucket.com/albums/bb406/jgloveracob/photo-2.jpg[/img]


I dont know if you can see or not but its barley sticking out.

So my question is... Do you think its the brass or the firing pin? Can I adjust the pin or is it time for a new one?