Hi guys! I have a new Model 12 VLP single shot with the lightweight accu-trigger that is suffering from an unhappy union with its factory laminated stock. I would really like to attempt to remedy this situation by bedding it in Devcon. Problem is, I've never done this before, and it seems highly likely that I would get some of this stuff into the trigger mechanism. My question is, is it possible to remove the Accutrigger without fouling it up, and if so, how do you do it? It seems that bedding this action would be much simpler without the trigger attached, since there is no magazine cutout on this model, just a smooth round underside, with the exception of the trigger of course. Any help would be greatly appreciated; thanks in advance.