I got some free time with the CNC Lathe and decided to make my own 110 BA styled Tactical Bolt Handles. They are about the same length as an SSS Tactical Handle and about the same weight as a standard Savage BT handle. I personally like the good grasp I get from them and I think they look pretty good. I made them from a couple of old Savage Sporter handles I had extra, by using the factory handles as donors. As far as installation it was pretty much just -cut off the old handle - drill out the old handle base - remove burrs - glue in the new handle shaft with red loc-tite. I tell you what, that CNC can crank 'em out in no time.


[img width=337 height=450]http://i747.photobucket.com/albums/xx111/bootsmcguire/bolthandles.jpg[/img]

From top to bottom
Savage BT Handle
SSS Stainless Tactical Handle
My Custom Handle (2nd design)
My Custom Handle (prototype)

Both my handles are made from Cold Rolled Steel and still in the white.
I would have taken more pictures but my camera crapped out after this one.