Picked up a Hogue stock with the full bedding block for the 300BO project and having some issues.

When you place the barreled action in the stock and snug up the action screws it seems to bind.

If action screws are tight you cant hardly cycle the action- neither is bottoming up locking the bolt in its just that torqued.

You can feel the action rock in the stock.

Have tried spacer, different action screw lengths and nothing seems to work.

Also the old internal mag doesn't fit, the bolt wont enter the action without pressing down on it. Then when you cycle a dummy round it catches quite a bit.

Put everything back in the original stock everything runs great.

Suggestions?

Is this common, just got a lemon?