Hello all,

So I just got a left hand 110 Storm. Tonight I made an attempt to swap out the factory extractor/ejector with the upgraded kit from Kinney's Shooting Supply. I used the same kit to fix weak ejection on a Lightweight Storm (right handed) last month. Extractor swap went fine. But after removing the factory ejector I had trouble installing the upgraded one. After a few failed attempts I looked at the right handed bolt from my other 110 and noticed a difference.

These two photos are of the left handed bolt:

https://ibb.co/9Nc6fym


https://ibb.co/r0nqP6b


These are of the right handed bolt:

https://ibb.co/h74gqv9

https://ibb.co/92kFG39


The retainer pin for the ejector only goes in from the side with the half moon cut out. On the right handed bolt, this half moon cut out is on the same side as the ejector, so it's easy to insert the pin and retain the ejector.

On the left handed bolt, however, it's on the opposite side. When I tried to insert the retainer pin it wouldn't reach far enough to actually retain the ejector. I didn't notice any of this prior to removing the factory ejector, so they must've have made it work somehow.

I'm assuming I'm being an idiot and there's an obvious solution I'm just not seeing.

1) Are all left-hand 110 bolts set up like this? (i.e. the opening for the retainer pin on the opposite side of the bolt from the ejector)

2) How are you supposed to get the retainer pin in?

Thanks in advance for any help.