I use a lee collet die to neck my .308 rounds and i shot my better groups with this die as it does produce rounds with less run out than my standard conventional type dies and yes i have a guage to check them. In the past ive set it up to use the same neck tension grip on the bullet as my forster neck die, but im startin to experiment and sort them into different lots based on different tensions. Is there a point where less is not good? You can hold them in ur hand and seat them with ur thumb. I load small bathes at a time as its very boring to me but out of 16 so far 3 of them literaly feel through the case and i will have to redue those. My two guestions are first the ones that actually hold the bullet but u can seat with ur thumb are they safe? and second with that little of neck tension will they perform or will it hurt acuracy. Any detailed help will be much welcomed.