Well got a factory take off 6.5 284 barrel borrowed a ptg headspace gage for it but on the gage it says 284 win on the gage but according to ptg it is the right gage. So next i had some left over 284 brass that i figured i would neck down with my new hornady dies tht say 6.5-284 sobi figured this will be a piece of cake well turna out my bolt wont close on the rifle. Also check the cartride oal before trim and was already undersize. So after i made numerous attepts to bump the shoulder back a cant get my press to cam over anymore to size brass.. so where do i start hornady or ptg for the gage?? Anyone else have this problem