MY 10FP was not extracting and ejecting, leaving the brass laying on the follower. I replaced the ejector and spring (curved like a snake when I managed to pull it out) and extractor. I replaced the extractor ball with the larger ball. The extractor and ejector is Savage original equipment. The ball I ordered online. The brass now extracts and ejects. I searched the forums and followed common practice in reassembling the bolt. I find that previously full sized 308 brass is tight chambering. Many will not chamber at all. If I loosen the BAS to the point where the bolt handle is sloppy loose, the brass will chamber. Re-tighten the BAS, it won't chamber. Clearly the issue is the new extractor and/or ejector. I will resize the brass so that they will chamber as before. Has anybody experienced this, and am I overlooking anything important?