Has anyone else run into this problem with a model 111 lrh. mine is in the 300 win mag. i have an ior valdada riding on top of it that when zeroed, i only have 1.5 mil left in right windage adjustment. i have swapped the rings front to back, side to side , bedded the rail, all to no avail. i am at the point of thinking the tap holes on the top of the receiver are out of alignment with the bore axis. i am going to mount the scope on another rifle that i know is correct and check the scope again. with iors quality control i am having a hard time believing its the scope. i have a new badger ordinance rail to install to eliminate that as well. i purchased the rifle new, so i know what has and hasnt been done to it. i wouldnt think that it would be that far out of alignment, but it isnt looking good. if it is, even if savage makes good and fixes it, i wont buy another. especially since they know about this problem with their other rifles, but keep putting them out.