Looking for advice:

I was assembling new bolt heads and, while driving the retaining pin for the ejector into place, I jammed / jaked something up.

The pin was only 2/3 or so thru when I stopped, double-checked for function and noticed the ejector was jammed flush with the bolt face and would not spring back out. I tried backing the pin back out by pulling with pliers, but couldn't so I punched it back out with a slave pin from the other side.

The ejector is still stuck in the "down/compressed" position even though I can easily run a slave pin thru the hole for the retaining pin.

Stumped, I put it in a zip-lock baggy and sprayed some Kroil on it hoping it will work itself loose. That was 10 mins ago.

Any other suggestions?