I am really happy with my money saver stock from Stockade. It is for my model 10 .30-06 with accutrigger. The internal magazine fits in very tightly--as promised. However, the first time I put it in I couldn't get the front action screw to reach the threads, so I took it out and looked more closely and noticed a very small lip at the bottom near the rear of the slot cut into the stock for the magazine. I seated it again down to that lip, then I tapped the front end of the magazine with a plastic hammer until it was all the way to the bottom of the hole. In other words, the back of the magazine was on the lip and the front was all the way down to the bottom. Then I put the stock back on and tightened it down.

So here is my question: Did I do that right?