I know this topic has been on here over and over, but I was wondering if someone could lead me along the path to success!
I cut down a couple 308 cases to 260 length and ran them through my 6.5 new dimension dies just for curiosity. The result was a case that looked alot like my 6.5 CM cases. Overall length matched and side by side I could not tell a difference. I was really excited and loaded one to try and it just won't chamber. I think the shoulder is still a little high but thats a hard measurement to make! I am bottomed out on my die so I guess the next step is to buy another die and shave the bottom? Anybody have this particular problem? It is so close to chambering it makes me want to cry. I only ran two steps to get it here so I was hoping for cheap, easy 6.5 brass!