Hello everyone, I have a BVSS Model 12 w/o accutrigger.
Have installed a Timney instead.
I was at the range today putting wonderful groupings at 100 yards with Federal .223 "Valuepack" ammo. I have never had any problems with this ammo before; but today 2 out of 30 rounds failed to fire.
The primer strikes seemed to be fairly light, and we all agreed it was probably the gun and not the ammo.
My question is would it be a good idea to replace the firing pin spring, or is there something else that should be looked at?
I did put a new SSS tactical bolt handle on before I took it to the range; though I doubt if that would cause it.
Any ideas? ???