Hello everyone, I seem to shoot 2 consistent groups. IE: two shots will cut and then the next two will cut, but be an inch lower in the exact same pattern. I can't tell if its me flinching consistently or of it is the optics or mounts?

I have the rifle bedded in a bell and Carlson medalist stock with aluminum bedding block. It's a 300wby cartridge.

Optics are burris 6-24x44 signature scope. It has their forever warrantee.

I am not sure on the base and rings as I bought the rifle used.

It still shoots sub MOA, but if that issue was able to get squared away I should be able to shoot a 4 shot group at .30" instead of 1.0" at 100 yards. I have tried different hand loads and it doesn't seem to matter. I can never get all 4 to cut. They are always the same pattern, just the second 2 are ALWAYS 1" low.

Once I get enough posts to attach a picture I will.