After reading a bunch about the Accuwedge and that it has been discontinued, I have decided to bed my Model 10 Precision Carbine to avoid any accuracy issues in the future. So now I had a few questions regarding the bedding...

1. Should I just bed the recoil lug area only and not further down the action? I thought this may be better than since the main issue was the Accuwedge and the action would still interface with the aluminum on the action.

2. Masking tape on recoil lug? Is this necessary if you use a release agent? I will be using the Brownell's release agent liquid. If the tape is necessary, would electrical tape be better than masking tape?

3. Should the face of the Accuwedge that contacts the recoil lug be ground down to have .030" clearance so it does not make contact with the recoil lug and leave it in place and cast the Devcon around it?

Any comments would be appreciated. Thanks.