Howdy all...

As this is the first time I have swapped a bolt handle out, I have a couple quick questions... I ran through the FAQ's and search, bt did not find what I was looking for.

As described in the title it's one of the new 111's. I removed the bolt and as it's in the cocked position, I popped the pin releasing the firing pin tension. Now here is where it gets dicey.. I swear I heard something ping off the wall when I did that! Is there anything that can fly out just by releasing the firing pin tension?

Used the 1/4 Allen wrench, broke the tension loose and removed and replaced handle. Placing the firing pin back in the cocked position, I tightened the nut as much as possible, as the pin starts working back up through the nut.

Slipped the bolt back into the receiver and finished tightening the nut. Heck... I think I did it right..

Do you guys use any thread locker (blue) on the screw in nut?

Thanks...

Bill