The trigger on one of my 110 actions is too tight / hard to pull. I've run out of options on making it lighter. I've replaced the spring with a thinner spring wire, polished the sear & it's contact point, cleaned & lubed, aligned, cursed & kicked the wall....
I think I've covered everything.
The only way I can explain this is, it's hard to pull to the point where it takes alot of concentration on trigger pull because if I don't pay attention, I'll yank the trigger & pull the shot.
Almost feels like a burr grabbing & then *snap*.... A crisp, clean break.
I guess it's time to open up the 'ol wallet & go with a new trigger.
By the way, this is an older action I'm referring to. Made around '97 - '98...
What's the preferred trigger these days? Timney or Rifle Basix?
If any of y'all have any experiences with either one - good or bad - i'd like to hear it.
Thanks.
Frank in Fla
Bookmarks