I'm ready to install pillars in my Boyds thumbhole. I knocked out that plastic bushing for the forward screw, it was set too deep in the first place, had screw going into the bolt lug and not even close to tight. So, got to looking at pillars and I like the idea of the threaded aluminum part that screws in and out.
So what I'm thinking is, take some measurments and I should be able to set it up so that my screws will work without having to shorten them.
Wondering if any of you have used these pillars and how you liked working with them?
Thanks~! Len

Also, I was thinking of installing the rear pillar and after setting up it looks like there plenty of room to get in there to cut it out for the trigger sear with a dremel cutoff wheel on a 90deg drive. Sound about right?