Hello Everyone!
I just got done bedding my new 338 edge built on a savage la into a factory BVSS stock with original pillars. Have done one other savage rifle and it turned out well. Did everything the same as far as taping the barrel to center and set the action to the right height. Action popped out good and got it all cleaned up. Let it fully cure and when I set the action in the stock it fits like a glove but when I tighten the rear action screw it takes awhile to bottom out and produces gaps on the side of the stock at the rear. Front screw bottoms out and torques up fast. Looking for advice as to what would cause this. I floated the tang area when I bedded it like everyone suggests. Sorry for the long post just trying to give all info I can!

Thanks!
Chance