They should be very close to each other.
Can anyone tell me if the size is the same between the ss trigger guard & the plastic guard on the stevens? I see I'll probably have to shim the front, I just want to make sure I don't have to carve up my stock to get it to fit. I inletted my stock to fit the plastic guard, but would like to replace it with a ss guard if possible. :)
They should be very close to each other.
I think if I had to mod something, I would take a little off the trigger guard and not the stock. I would hate to ruin either one, but if I did I know I would rather replace the cheaper and possibly the easier of the two to replace.Originally Posted by r29l20
Now if your talking the factory stock then maybe I would mod it.
Good luck with your project.
I just replaced a plastic guard with a metal one and it dropped in place with no modifications to the factory stock. If you modified your wood stock, a few washersfor spacers may be required to bring it to the correct level.
Vietnam Vet, Jun 66 - Dec 67
Thanks guys. :)
Bookmarks