Results of my first 1,000 yd. Benchrest club competition.

[joseph]

This was the very first time I had ever shot at a paper target at 1,000 yds. The mirage was so bad that I had to change my magnification from 24x to 12x so I could "kinda" see the target.

We had 2 relays. At the beginning of the first we were allowed 3 sighter shots. Then we had a 20 minute time limit to shoot a 10 shot string to be recorded for group size and score. The second relay was no sighters just 20 minutes to shoot our second 10 shot string for group size and score.

My first ever 3 sighters centered just outside the ten ring at 4 o'clock. I moved my Vortex PST turrets one click left and one click up. When the target was scored I had a 91-1x with a 10 shot group that measured 14+1/8".

The wind changed for my second 10 shot string and I read it backwards. The group went higher. It scored 82 and the group measured 17+5/8".

Well in benchrest class I came in second with a 173-1x The first place was 174-1x and he had smallest group of 9+3/8"

Now I will experiment with jamming the 105 gr. Berger VLDs into the rifling. I'm shooting a 6mm Norma BR. Maybe this will get my group size smaller and bring my score up.

joseph

[Hammer]

.

Congratulations !

Great work.

.

[geargrinder]

Nice job!

Tell us about your rifle.

[joseph]

Nice job!

Tell us about your rifle.

http://forum.gon.com/showthread.php?...73#post5958873


It was built by Kevin Rayhill at Stockade Gun Stocks. http://www.stockadegunstocks.com/

I had Brux Barrels send a 6mm barrel blank directly to Kevin. At the same time I sent my Coplan hard rifle case with a Savage Target action with the left load port and right eject bolt with the target accu-trigger.

I had Kevin turn the contour, bore the chamber for .271 no neck turn 6mm Norma BR. so I can touch the lands with 107 gr. Berger & smaller to maybe 80 gr(?). He also threaded it and cut it to 26" and crown the end. I asked him not to blueprint the action to save a few nickels. Then he assembled everything into one of his Prairie Dog Special/Tactical stocks that he put a third pillar and glass bedded it for me. I asked him not to finish and paint the stock so I could save some more nickels. (Looks like very little filling and sanding). I had him add the rail under the forearm so the bipod could be adjustable. I also had the adjustable cheek piece added along with a flush mounted swivel stud added under the butt stock so it would slide on the rear bag better.

When I talked to him before he sent it he told me that he shot 7 rounds using Varget and Berger 105 gr. Match VLDs at 100 yards. First two shots to get on the bullseye and then 5 shots for group size. This was never fired Lapua brass. He said I have a "HUMMER". The group measured .084". WOW!!

To say the very least I am very excited.

I bought 4 cans of spray paint and will take before, during and after finished pictures of it and post them here for all to see.

"Aim small miss small",

joseph

PS: If I had gotten the action from him I would have saved more nickels too.
Total $1443.00 including shipping.