Just bought a Stevens in 223. I have some 5/16 inch rods that I am going to JB weld into the forearm channels. The end of my stock is touching at the end on the left side. Should I dremmel this area out or put tape around the barrel to center the stock and then let the jb weld and steel rods straighten it out?? I am just worried about adding stress. Also I have some Devcon 10110 to bed the action. Should I just bed the front lug and not worry about the rear action screw. It looks like the rear would be difficult to bed with the metal clip holder on there. I have bedded my Rem 700 in a aftermarket stock and it turned out well. This looks like it's going to be a little more difficult though. Any help would be greatly appreciated.