Just go ahead and use the gages.
Bill
I will be finishing up my first build, and started to wonder if there was a specific distance I should set my headspace to, or just use my go/no go gauges and be done with it?
model 10, timed and trued (sss), 30" stainless select match shilen barrel (no taper), bell & carlson medalist varminter stock.
I am hoping that that it will like the smk's.
Just go ahead and use the gages.
Bill
will do.
is there an optimal length? Or will that be purely controlled by the length of the cartridge?
(is there an optimal cartridge length that you would ever set headspace(including freebore) to get?)
Am I getting too far into something that isn't there?
Since headspace on a rimless cartridge is the distance from a datum line on the shoulder to the breach face, free-bore is not part of the equation. Free-bore is set when the chamber is cut. Just go ahead and use your go/no-go gages.
already got it done. ;D
I tried the smks with your same barrel and twist. It liked the Berger 168 vlds much better. The vlds like to be close to the lansOriginally Posted by Toyoda
I went with a 1:12 twist, I didn't mention that. ???
Bookmarks