I'm replacing my RCBS hand primer that went belly up cracking two places in the diecast zinc frame. It was an older one w/o the primer feed. I was leary of buying another RCBS after that happen in only three years of use so went with the Hornady instead because of it's aluminum frame and was cheaper than the RCBS. I'm not at all crazy about primer feeds having had nothing but problems with a Lee system so I'm going to use the Hornady like a standard single feed priming tool. Did I make a good choice or am I throwing away money on a POS. I would have preferred one of the better benchrest primer seaters from Sinclair but didn't care to take out a mortgage and have to give up my first born to boot.