I just recieved a new unfired Stevens 200 in 25-06 from a dealer on Gunbroker with I believe a too long throat. I use the Hornady overall length gauge and using Sierra 100 gr bullets I can't touch the lands and keep the bullet in the case. When I pull out the tool the inner push rod is at the very end of the case. To seat the bullet a calibre's diameter in the case I will have a jump of around .250 and that can't be right. I tried 75 gr Sierras and 85 gr Nosler CTs and they were much worse as expected. The pushrod was completely out of the modified case. I also compaired the modified case against new Remington brass and the length was the same. There is no way possible to seat the bullet anywhere near the lands. Anybody else have this problem with the 25-06 and should I contact Savage?