extractor,spring & detent ball
drybean
Good Evening
While I was lubing up my Savage bolt, I applied a little downward pressure on the extractor and it came out of the bolt, and some parts went flying out. I looked all over for the parts, but had no luck finding them. Does anyone have an idea what parts I will need to replace, and where I can find them.
Not a good Day, Ken
extractor,spring & detent ball
drybean
They all should be available at midway. There are three parts the extractor, the spring, and a ball bearing. If you need part #'s I can get em for you
Silence is golden.... duct tape is silver!!
I really hate it when parts launch themselves. ( I did it too so don't feel lonely)
Whenever the legislators endeavor to take away and destroy the property of the people, or to reduce them to slavery under arbitrary power, they put themselves into a state of war with the people, who are thereupon absolved from any further obedience
just a though....are we sure he's not talking about the ejector vs the extractor? i don't know how the ejector would come out like that but i guess it's possible if it broke in half.
16-223, 10 223, 10 FCP 308, 111 30-06, 110 30-06, 111 6.5x55, 112 338-06/6mm Rem, 110 300 WinMag,
No, it's the extractor. I just did a quick check on the Savage site, and found the parts with their parts finder. Thank's for the info, I think I'm good to go until urf up something else.
Ken
Assemble or dis-assemble in a zip lock bag. How do I know, I just launched two bearings and the spring from a rear baffle. I was lucky, I found everything.
Bookmarks