Really not trying to max it out. Just need a lumbering brush hunting load that balances with my other loads.

Right now I have 3 balanced loads on paper that work with the Leupold LR reticle scope I have mounted
but I still need to test the loads and make sure they work together. I will still have to tweak them a bit.

Unfortunately someone stole my chrono so...

IE the 220 prohunter is zeroed at 100 yards. Its a round nose bullet and shoots good enough for hunting out of my rifle. Although I will probably never use this load over 100 yards, that gives me roughly

dot1 - 175
dot2 - 235
top of bar - 300

2" low at 150

Also 130 gr barnes same scope setting running at close to max
Zero is 200 yards with the same scope setting

dot1 - 300
dot2 - 395
top of bar - 475

2.6" low at 250

Also a 110 gr Vmax and 110 gr TSX reduced load
Roughly zeroed at 175 yards with the same scope setting.
Don't care about hold over LR reticle for that one so much.

That will shoot from 0 to 200 no higher than 1.2", and low 1.2" at 200
Sort of a hold on 0-200 yd round for target, coyotes, hog head shots etc.

dot1 - 280
dot2 - 350 - Not much energy past 350
top of bar - 425