Stock project

[J A XSP]

I hope to have an extra at some point that I can send down your way, Bobby.
I'll get this set sanded and finished and see how it feels at the bench and then I'll get a start on the beta version.
It'll take a little time to work out the kinks but if I get a shape that seems to work really well, I'll rig up a duplicator router so I won't have to sculpt it all by hand. That'd be the only way I could come close to making anything on the time expended. :)

[BT]

Impressive! You’re moving right along.

[BobT]

I don't see anything that looks skimpy about that stock. I think it looks great!

[J A XSP]

I don't see anything that looks skimpy about that stock. I think it looks great!

That area right behind the top/back of the frame is cut too close to the slot. It makes it hard to get a good shape around the corners of it. It needs a little meat behind the slot so the corner areas can be rounded into the wings and give it a good feel.

[Steve The Chimney Sweep]

That came out fantastic, you have a lot of talent.

[J A XSP]

Thanks!
That particular stock will definitely work and I'll need to finish it out pretty quickly because I have a Lynx SSK frame inbound as well as a new barrel that should be here next week. I've got another one ready for shaping and I should be able to rough it out quicker and refine a few lines based on what I did with the first one. Fun project but my shop is really, really full of walnut chips and sanding dust right now. :)

[J A XSP]

I got a few coats of finish on just in time to pick up my new Lynx frame from my FFL. :) I like the feel of the stock. This one is definitely a bit of a rough prototype and I'll make some refinements but it's fully functional. :)