That's a project I pondered for a while. Fueled by finding an old Mauser action that had seen better days. I passed on it. Every now and then I think about finding another action to work on. But, these days even a junk action goes for what I think is an insane amount of money.
So are you also going to make it a 'barrel nut' job?
I thought about making it with a nut, I will decide once I get the inner ring machined out and see whats what. Heck I might machine it out sleeve it and thread it for Savage barrels, maybe.
I think I've found a mauser action to work on. I haven't done a pull through reamer before but I may try that method for this one. I don't think this barrel will ever be changed since it will be a cast bullet only rifle.
Bookmarks