4.27" stagger feed short action.
I bought a Shaw 8.6 BO barrel when they were on sale and finally got around to setting it up.
However, I am having problems getting it to feed. Before this barrel, it was a 6.5 creedmor or 7mm-08 and both of those fed fine.
At first the magazine feed lips were too straight and the bullet nose was jamming and not hitting the ramp.
So I bent the lips up slightly mostly towards the front and kept the lips as straight as possible.
That helped and it will feed the 1st cartridge of 4, but it wont feed the 2nd cartridge.

The 8.6 BO shoulder is so far back, that when I try to cycle the 2nd round, it tilts on corner of the shoulder pinned between the cartridge underneath and the feed lips and never fully seats on the lips. So the bolt rides over it. I can push the nose down so that the bolt will catch it, but then it nose dives. If I push the back down the bolt will miss the case head and ride over it.

Any suggestions?
All are welcome.